![]() I'm using the default settings aside from changing the root password, renaming the SSID, enabling WPA2 Personal wireless security, and pointing DNS at DNS.WATCH's resolvers. On my fairly vanilla configuration I have 2 full days of uptime, 16,000MB of ingress, and 800MB of egress behind me. I followed the Flashing Instructions including the Current Editor's Note, which took me from the Linksys firmware it came with to DD-WRT build 33555 mega, and then I flashed to 33986 from there. Time: 15:54:21 up 2 days, 5:10, load average: 0.16, 0.13, 0.07īased on jpp's comment, I decided to put this same build (dd-wrt.v24-33986_NEWD-2_K3.x_mega-nv64k.bin) on my Cisco/Linksys E1200 v2 as my very first foray into DD-WRT. I have been testing 33986 build (with Krack patch) for the last days on my secondary AP and so far so good.įirmware: DD-WRT v3.0-r33986 mega (12/04/17) PostPosted: Mon 1:06 Post subject: Reply with quote ![]() Is this a good build to use with the E1200 and do I have the correct understanding of the procedure to be followed? Wait at least 3 mins (maybe 5 or more!).Ĥ) Power cycle the router and wait for lights to settle (maybe 2 or 3 mins).ĥ) Perform hard (30/30/30) reset, login and proceed to configure the router for repeater bridge. For clarity, I understand the update process to be:ġ) Remove computer from wireless/internet and connect to the E1200 using an ethernet cable.Ģ) Perform 30/30/30 reset of the router and allow time for the router to reboot.ģ) Login to router and flash 33986 firmware from the webgui update page. ![]() Per the post below I'm thinking that build 33986 (dd-wrt.v24-33986_NEWD-2_K3.x_mega-nv64k.bin) would be reasonable to install on the router. I'm assuming that I should perhaps take this opportunity to update to a newer build?. So it seems that the only way to get repeater bridge working is to reset the router. I'd like to switch from client bridge to repeater bridge to improve wifi signal strength on first floor of house however I stupidly did not save the account/password that I used when configuring the router initially. I installed this firmware a few years back and everything seems to have been working fine (the router gives network access to my Yamaha receiver). ![]() I have a E1200 V2 that is currently running in client bridge mode using DD-WRT v24-sp2 (05/27/13) - SVN 21676. Posted: Tue 15:43 Post subject: Update to Linksys E1200 ![]()
0 Comments
Leave a Reply. |